Naming Supply Colors - Brady GlobalMark 2 User Manual

Cutter
Calibration:
Horizontal (x)
Vertical (y)

Naming supply colors

When new tape or ribbon supplies become available after your print system is
shipped to you, your system will not have internal information about those new
supplies. The Check Supply Colors button lets you supply the names of new
supplies and store them in your system.
To supply names for new ribbons or tapes
1. Install the new tape or ribbon in your system.
2. Choose the Check Supply Colors button on the Hardware options tab.
The Check Supply Colors screen displays:
Sample of
color to be
named is
shown in the
Multicolor and
Color & Cut
systems only.
Color & Cut system only. Re-sets the factory-set
calibration values for the plotter cutter in your
system. Enter positive or negative whole numbers
to adjust the horizontal or vertical values by one/one
thousandth of an inch for each increment.
Note: Use caution when calibrating your plotter
cutter. To return to the factory-set values, see the
calibration label placed inside your printer at the
factory, and reinstate the values shown on that label.
See Calibrating the Cutter on page 10-11 for more
information.
Figure 5-4. The Check Supply Colors screen.
Setting Preferences
5 9
-