2. Holding the stylus holder perpendicular to the surface, glide the stylus nose
lightly cross the tape. need diagram with new stylus holder
Note:
3. Check the tape to see if the cut is correct. The cut should go through the tape,
but leave the backing paper unscored.
Step 5:
Make any adjustments required to the stylus depth, then test again.
Step 6:
Reinstall the stylus holder. Seat it in the mechanism, then turn it clockwise until it
stops.
B-6
Adjusting the Cut Depth
Figure B-4. Testing cutting depth.
Apply slight pressure. Make sure the stylus holder is positioned straight
vertically.