Cisco MDS 9124 - Fabric Switch Reference page 951

Chapter 21 S Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
sme
To enable or disable the Cisco SME services, use the sme command.
Syntax Description
auto-save
cluster name
enable
transport
pre-shared
key key identifier
cluster name
Defaults
Disabled.
Command Modes Configuration mode.
Command History Release
3.2(2)
Usage Guidelines
Cisco SME services must be enabled to take advantage of the encryption and security features.
To use this command, you must enable Cisco SME clustering using the cluster enable command.
Examples
The following example shows how to enable the Cisco SME service:
switch# config t
switch(config)# sme enable
switch(config)#
The following example shows how to disable the Cisco SME service:
switch# config t
switch(config)# no sme enable
switch(config)#
The following example shows how to enable automatic configuration save after the changes:
switch# config t
switch(config)# sme auto-save
switch(config)
OL-16217-01, Cisco MDS SAN-OS Release 3.x
sme {auto-save | cluster name | enable | transport pre-shared key key identifier cluster cluster }
Enables or disables the auto-configuration save after the changes are made.
Identifies the cluster name. The maximum length is 32 characters.
Enables or disables Cisco SME on the crypto mode.
Configures the transport preshared key (PSK).
Configures transport PSK.
Specifies the PSK. The maximum length is 64 characters.
Identifies the cluster. The maximum length is 64 characters.
Modification
This command was introduced.
Cisco MDS 9000 Family Command Reference
sme
21-33