Chapter 14 L Command; Line Com1 - Cisco MDS 9124 - Fabric Switch Reference

Chapter 14 L Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

line com1

To configure auxiliary COM 1 port, use the line com1 command. To negate the previously issued
command or to revert to factory defaults, use the no form of the command.
Syntax Description databits number
flowcontrol hardware
modem
in
init-string default
set-string user-input
string
init-string user-default
parity
even
none
odd
speed speed
stopbits
1
2
Defaults
9600 Baud
8 databits
1 stopbit
Parity none
Default init string
OL-16217-01, Cisco MDS SAN-OS Release 3.x
line com1 -->
databits number |
flowcontrol hardware |
modem {in | init-string {default | user-input} | set-string user-input string} |
parity {even | none | odd} |
speed speed |
stopbits {1 | 2}
line com1 -->
no databits number |
no flowcontrol hardware |
no modem {in | init-string | set-string user-input} |
no parity {even | none | odd} |
no speed speed |
no stopbits {1 | 2}
Specifies the number of databits per character. The range is 5 to 8.
Enables modem flowcontrol on the COM1 port.
Enables the modem mode.
Enables the COM 1 port to only connect to a modem.
Writes the default initialization string to the modem.
Sets the user-specified initilization string to its corresponding profile.
Maximum length is 80 characters.
Writes the provided initialization string to the modem.
Sets terminal parity.
Sets even parity.
Sets no parity.
Sets odd parity.
Sets the transmit and receive speeds. The range is 110 to 115, 200 baud.
Sets async line stopbits.
Sets one stop bit.
Sets two stop bits.
Cisco MDS 9000 Family Command Reference
line com1
14-3