Nwwn (Dpvm Database Configuration Submode) - Cisco MDS 9124 - Fabric Switch Reference

Chapter 16 N Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

nwwn (DPVM database configuration submode)

To add a device to a dynamic port VSAN membership (DPVM) database using the nWWN, use the
nwwn command in DPVM database configuration submode. To remove a device from a DPVM database
using the nWWN, use the no form of the command.
Syntax Description nwwn-id
vsan vsan-id
Defaults
None.
Command Modes DPVM database configuration submode.
Command History Release
2.0(x)
Usage Guidelines
To use this command, DPVM must be enabled using the dpvm enable command.
Examples
The following example shows how to add an entry to the DPVM database.
switch# config terminal
switch(config)# dpvm database
switch(config-dpvm-db)# nwwn 11:22:33:44:55:66:77:88 vsan 1
The following example shows how to delete an entry from the DPVM database.
switch(config-dpvm-db)# no nwwn 11:22:33:44:55:66:77:88 vsan 1
Related Commands Command
dpvm database
show dpvm
OL-16217-01, Cisco MDS SAN-OS Release 3.x
nwwn nwwn-id vsan vsan-id
no nwwn nwwn-id vsan vsan-id
Specifies the node WWN ID. The format is hh:hh:hh:hh:hh:hh:hh, where h
is a hexadecimal number.
Specifies the VSAN ID. The range is 1 to 4093.
Modification
This command was introduced.
Description
Configures the DPVM database.
Displays DPVM database information.
nwwn (DPVM database configuration submode)
Cisco MDS 9000 Family Command Reference
16-17