Removing The Driver And Client Utility - Cisco AIR-PCM340 Installation And Configuration Manual

Removing the Driver and Client Utility

Step 8 When the Cisco WLAN Install screen appears, perform the following operations:
a.
b.
When a screen appears indicating that you must restart your computer after installing the software, click
Step 9
Continue.
Note
A message appears indicating "One moment please..." then a screen appears that shows the installation
Step 10
progress. After the files are copied to the designated folder on the Macintosh hard disk, a screen appears:
If a message appears indicating that the installation was successful. Perform one of the following steps:
Step 11
•
Note
Step 12 If a message appears indicating that the installation is not necessary, click Quit. The installer has
detected that your installed software is the same version as the software to be installed.
Removing the Driver and Client Utility
This section provides instructions for removing the driver and the client utility from your computer. The
following procedure removes the driver and the client utility for both Mac OS 9.x and Mac OS X.
Step 1 Locate the client utility installer (Cisco WLAN Install) on your hard drive.
Step 2 Double-click Cisco WLAN Install.
Step 3 For Mac OS X, when the Authenticate screen appears, enter your password in the Password field. Your
Macintosh user name will appear in the Name field. Click OK.
Note
Step 4 When the Cisco Aironet Wireless LAN Adapter Software screen appears, click Continue.
Step 5 When the Software License Agreement appears, click Accept.
Cisco Aironet Wireless LAN Adapters Installation and Configuration Guide for Mac OS
8-4
Expand the Mac OS software component list by clicking the right triangle on the left of Mac OS
name.
Both the PCI and PC Card drivers are normally installed by the installer. You can deselect
Note
one of the drivers by clicking the selection box to remove the X; for example: you can
deselect the PCI driver when using a PowerBook or you can deselect the PC Card driver
when using a PowerMac.
Click Install to begin the installation process.
You can click Cancel to terminate the installation process.
Click Restart to restart your computer and finish the client utility installation.
The client utility, the help files, and the driver are installed by the installer.
To uninstall the client utility on Mac OS X, you must have administrator privileges for the
Macintosh.
Chapter 8 Routine Procedures
OL-1377-01