Inserting A Pci Client Adapter - Cisco AIR-PCM340 Installation And Configuration Manual

Chapter 3 Installing the Driver, Client Utility, and Client Adapter
Figure 3-3
Note You can remove and reinsert your PC card when necessary. Refer to the
section on page 8-6
Step 3 Perform one of the following operations:
a.
b.

Inserting a PCI Client Adapter

Caution Static electricity can damage your computer and your client adapter. Before opening your computer
or removing the adapter from the anti-static packaging, discharge static by touching the metal PCI
port covers of your grounded computer (connected to a grounded power connector).
Step 1 Turn off the computer and all its components.
Refer to your Macintosh computer manual for instructions on opening or removing your computer
Note
cover and on locating the PCI expansion slots.
Step 2 Remove or open the computer cover.
Locate an empty PCI expansion slot in your computer.
Step 3
Examine the client adapter and ensure the antenna is not attached to the card. The antenna connector and
Step 4
the LEDs face out of your computer and are visible when you put the cover back on. The bottom edge
of the adapter is the connector you will insert into the PCI expansion slot.
Tilt the adapter to allow the antenna connector and LEDs to slip through the opening in the computer
Step 5
back panel.
Press the client adapter into the empty PCI expansion slot until the adapter is firmly seated.
Step 6
OL-1377-01
Inserting a PC Card into a Computing Device
for instructions.
If you are using the Mac OS 9.x operating system, go to the
section on page 3-11.
If you are using the Mac OS X operating system, go to the
section on page 3-2.
Cisco Aironet Wireless LAN Adapters Installation and Configuration Guide for Mac OS
Inserting the Client Adapter into a Computing Device
"Removing a PC Card"
"Configuring the Client Adapter"
"Installing the Driver and Client Utility"
3-9