Cisco AIR-PCM340 Installation And Configuration Manual page 39

Chapter 3 Installing the Driver, Client Utility, and Client Adapter
Step 11 If the Congratulations screen appears, your client adapter has successfully associated and sent data to an
access point. Perform one of the following operations:
a. Click Network Settings to configure your Macintosh network parameters. Go to Step 15.
b. Click Quit to configure your Macintosh network parameters at a later time. When you are ready to
complete the configuration of your client adapter go to the
on page
If the Almost There screen appears, this indicates your client adapter is associated to an access point but
Step 12
is unable to pass data through the access point. Perform one of the following operations:
Click Finish to exit the setup assistant and use the client utility to help resolve the problem. See
a.
"Troubleshooting" section on page
b. Click Return to Setup Assistant to revise your settings using the setup assistant. Return to Step 3.
Step 13 If the Troubleshoot screen appears, this indicates your client adapter is unable to associate to an access
point. The screen status information identifies the problem area. Perform one of the following
operations:
If you want to manually troubleshoot the problem or use the client utility to change your
a.
configuration settings, click Finish. See
Note
Click Return to Setup Assistant to revise your settings using the setup assistant. Return to Step 3.
b.
If the Done screen appears, read the screen information and click OK. This message appears when your
Step 14
client adapter is not installed in your Macintosh. Your configuration parameters are saved in your
preference file on the hard disk but your Mac OS X Network settings and your client adapter are not
configured. Perform the following operations:
Refer to the
a.
instructions on inserting your client adapter into your computer.
Note
Refer to the
b.
Mac OS X Network settings.
Go to
c.
When the Network screen appears, verify that the Location dialog box contains Automatic or click the
Step 15
Location up or down arrows and select Automatic.
Click the Show up or down arrows and select Ethernet Adaptor (enx) or PCI Ethernet Slot x (where
Step 16
x is a number that indicates a specific adapter or slot).
Click the TCP/IP tab. The TCP/IP window appears.
Step 17
OL-1377-01
3-11.
Installation problems are typically caused by mismatched parameter settings between the
client adapter and the access point. Check your settings for the Network Name (or SSID),
Network Type, your WEP settings, and your LEAP settings.
"Inserting the Client Adapter into a Computing Device" section on page 3-9
If you are using LEAP, a wireless network login screen appears when you restart your
computer. Enter your LEAP username and password. Click OK.
"Setting TCP/IP Options" section on page 3-13
"Verifying a Successful Installation and Configuration on Mac OS X" section on page
Cisco Aironet Wireless LAN Adapters Installation and Configuration Guide for Mac OS
"Configuring the Client Adapter" section
9-1.
"Troubleshooting" section on page
for instructions on configuring your
Installing the Driver and Client Utility
9-1.
for
3-15.
3-7