Table of Contents
Advertisement
Network Configurations Using the Client Adapter
Note
For information on setting the client adapter's antenna mode, refer to
Configuration on Mac OS 9.x"
Note
External antennas used in combination with a power setting resulting in a radiated power level above
100 mW equivalent isotropic radiated power (EIRP) are not allowed for use within the European
community and other countries that have adopted the European R&TTE directive or the CEPT
recommendation Rec 70.03 or both. For more details on legal combinations of power levels and
antennas in those countries, contact Cisco Corporate Compliance. See also the
Conformity and Regulatory Information" section on page
LEDs
The client adapter has two LEDs that glow or blink to indicate the status of the adapter or to convey error
messages. Refer to
Network Configurations Using the Client Adapter
The client adapter can be used in a variety of network configurations. In some configurations, access
points provide connections to your network or act as repeaters to increase wireless communication
range. The maximum communication range is based on how you configure your wireless network.
This section describes and illustrates the following common network configurations:
•
•
Note
For examples of more complex network configurations involving client adapters and access points,
refer to the Cisco Aironet Access Point Hardware Installation Guide.
Note
For information on setting the client adapter's network mode, refer to
operating system or to
Cisco Aironet Wireless LAN Adapters Installation and Configuration Guide for Mac OS
1-4
Chapter 9
for an interpretation of the LED codes.
Ad hoc wireless local area network (LAN)
Wireless infrastructure with workstations accessing a wired LAN
Chapter 6
or to
Chapter 6, "Advanced Configuration on Mac OS X."
for the Mac OS X operating system.
Chapter 1
Chapter 5, "Advanced
"Declarations of
C-1.
Chapter 5
for the Mac OS 9.x
Overview
OL-1377-01
Advertisement
Table of Contents
Troubleshooting
