Configure The Fast Ethernet Wan Interfaces - Cisco 1812W - Integrated Services Router Wireless Configuration Manual

Chapter 3 Configuring PPP over Ethernet with NAT
Command or Action
Step 3
request-dialin
Example:
Router(config-vpdn-grp)# request-dialin
Router(config-vpdn-grp)#
Step 4
initiate to ip ip-address
Example:
Router(config-vpdn-grp)# initiate to
192.168.1.1
Router(config-vpdn-grp)#
Step 5
protocol {l2f | l2tp | pppoe | any}
Example:
Router(config-vpdn-grp)# protocol pppoe
Router(config-vpdn-grp)#
Step 6
exit
Example:
Router(config-vpdn-grp)# exit
Router(config-vpdn)#
Step 7 exit
Example:
Router(config-vpdn)# exit
Router(config)#

Configure the Fast Ethernet WAN Interfaces

In this scenario, the PPPoE client (your Cisco router) communicates over a 10/100-Mbps Ethernet
interface on both the inside and the outside.
The Cisco 1800 series integrated services fixed-configuration routers have a hardware limitation on the
Note
Fast Ethernet ports FE0 and FE1. In half-duplex mode, when traffic reaches or exceeds 100% capacity
(equal to or greater than 5 Mbps in each direction), the interface experiences excessive collisions and
resets every second. To avoid this problem, you must limit the traffic capacity to less than 100%.
OL-6426-02
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
Configure the Fast Ethernet WAN Interfaces
Purpose
Creates a request-dialin VPDN subgroup,
indicating the dialing direction, and initiates the
tunnel.
Specifies the address to which requests are
tunneled.
For details about this command and additional
parameters that can be set, see the
Technologies Command Reference.
Specifies the type of sessions the VPDN subgroup
can establish.
Exits VPDN group configuration.
Exits VPDN configuration, returning to global
configuration mode.
Cisco IOS Dial
3-3