Configuring Ppp Over Ethernet With Nat - Cisco 1812W - Integrated Services Router Wireless Configuration Manual

Configuring PPP over Ethernet with NAT

The Cisco 1811 and Cisco 1812 integrated services fixed-configuration routers support Point-to-Point
Protocol over Ethernet (PPPoE) clients and network address translation (NAT).
Multiple PCs can be connected to the LAN behind the router. Before the traffic from these PCs is sent
to the PPPoE session, it can be encrypted, filtered, and so forth.
scenario with a PPPoE client and NAT configured on the Cisco router.
Figure 3-1
1
1 Multiple networked devices—desktops, laptop PCs, switches
2
Fast Ethernet LAN interface (inside interface for NAT)
3 PPPoE client—Cisco 1811 or Cisco 1812 integrated services router
4 Point at which NAT occurs
5
Fast Ethernet WAN interface (outside interface for NAT)
6
Cable modem or other server (for example, a Cisco 6400 server) that is connected to the Internet
7 PPPoE session between the client and a PPPoE server
OL-6426-02
PPP over Ethernet with NAT
4
2
3
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
C H A P T E R
Figure 3-1
5
6
7
3
shows a typical deployment
Internet
3-1