Configure the Dialer Interface
Command
Step 7
dialer-group group-number
Example:
Router(config-if)# dialer group 1
Router(config-if)#
Step 8
exit
Example:
Router(config-if)# exit
Router(config)#
Step 9
dialer-list dialer-group protocol protocol-name
{permit | deny | list access-list-number |
access-group}
Example:
Router(config)# dialer-list 1 protocol ip
permit
Router(config)#
Step 10
ip route prefix mask {interface-type
interface-number}
Example:
Router(config)# ip route 10.10.25.2
0.255.255.255 dialer 0
Router(config)#
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
3-6
Chapter 3
Configuring PPP over Ethernet with NAT
Purpose
Assigns the dialer interface to a dialer group
(1–10).
Tip
Using a dialer group controls access to
your router.
Exits the dialer 0 interface configuration.
Creates a dialer list and associates a dial group
with it. Packets are then forwarded through the
specified interface dialer group.
For details about this command and additional
parameters that can be set, see the
Technologies Command
Reference.
Sets the IP route for the default gateway for the
dialer 0 interface.
For details about this command and additional
parameters that can be set, see the
Command Reference, Volume 2; Routing
Protocols.
Cisco IOS Dial
Cisco IOS IP
OL-6426-02