Configure the Fast Ethernet WAN Interfaces
Perform these steps to configure the Fast Ethernet WAN interfaces, starting in global configuration
mode:
Command
Step 1
interface type number
Example:
Router(config)#interface fastethernet 0
Router(config-if)#
Step 2
pppoe-client dial-pool-number number
Example:
Router(config-if)# pppoe-client
dial-pool-number 1
Router(config-if)#
Step 3
no shutdown
Example:
Router(config-if)# no shutdown
Router(config-if)#
Step 4
exit
Example:
Router(config-if)# exit
Router(config)#
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
3-4
Chapter 3
Configuring PPP over Ethernet with NAT
Purpose
Enters interface configuration mode for a
Fast Ethernet WAN interface.
The Cisco 1800 integrated services routers have
two Fast Ethernet WAN interfaces. You can use
these steps to configure one or both of them.
Configures the PPPoE client and specifies the
dialer interface to use for cloning.
Enables the Fast Ethernet interface and the
configuration changes just made to it.
Exits configuration mode for the Fast Ethernet
interface and returns to global configuration
mode.
OL-6426-02