Cisco 1812W - Integrated Services Router Wireless Configuration Manual page 141

Chapter 13 Configuring Dial Backup and Remote Management
Line Configuration
Perform these steps to configure the line on the V.92 modem, beginning in global configuration mode:
Command
Step 1
line line-number
Example:
Router(config)# line 1
Router(config-line)
Step 2
modem inout
Example:
Router(config-line)# modem inout
Router(config-line)#
Step 3 autoselect {arap | ppp | slip | during-login |
timeout seconds}
Example:
Router(config-line)# autoselect ppp
Router(config-line)#
Step 4 transport input {all | lat | mop | nasi | none |
pad | rlogin | telnet | v120}
Example:
Router(config-line)# transport input all
Router(config-line)#
Step 5 exit
Example:
Router(config-line)# exit
Router(config)#
OL-6426-02
Configuring Dial Backup and Remote Management Through a V.92 Modem
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
Purpose
Identifies a specific line for configuration and
enters line configuration collection mode.
Note The number entered here must be the same
as the number entered for the
asynchronous serial interface.
Configures the line for both incoming and
outgoing calls.
Configures the line to automatically start an
AppleTalk Remote Access (ARA), PPP, or SLIP
session.
Note We recommend ppp for use with the dial
backup feature.
Defines which protocols can be used to connect to
the line.
We recommend all for use with the dial
Note
backup feature.
Exits line configuration mode, and enters global
configuration mode.
13-15