Cisco 1812W - Integrated Services Router Wireless Configuration Manual page 140

Configuring Dial Backup and Remote Management Through a V.92 Modem
Command
Step 4
dialer in-band
Example:
Router(config-if)# dialer in-band
Router(config-if)#
Step 5
dialer string dial-string
Example:
Router(config-if)# dialer string
T14085551234
Router(config-if)#
Step 6
dialer-group group-number
Example:
Router(config-if)# dialer group 1
Router(config-if)#
Step 7
async mode interactive
Example:
Router(config-if)# async mode interactive
Router(config-if)#
Step 8 peer default ip address {ip-address | pool
[pool-name]}
Example:
Router(config-if)# peer default ip address
pool pool123
Router(config-if)#
Step 9 exit
Example:
Router(config-if)# exit
Router(config)#
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
13-14
Chapter 13 Configuring Dial Backup and Remote Management
Purpose
Specifies support for dial-on-demand routing
(DDR) and chat scripts on this asynchronous
interface.
Specifies the telephone number to be dialed.
Assigns the dialer interface to a dialer group
(1–10), controlling access. The number to which
the dialer access group belongs is defined with the
dialer-list command.
Returns a line that has been placed into dedicated
asynchronous network mode to interactive mode,
thereby enabling the Serial Line Internet Protocol
(SLIP) and PPP EXEC commands.
Assigns IP addresses to remote clients, using an
address pool. To create an IP address pool, use the
ip local pool global configuration command.
Exits asynchronous interface configuration, and
enters global configuration mode.
OL-6426-02