Cisco 1812W - Integrated Services Router Wireless Configuration Manual page 110

Configuration Example
Command
Step 3
encapsulation dot1q vlanID [native |
second-dot1q]
Example:
Router(config-subif)# encapsulation dot1q 1
native
Router(config-subif)#
Step 4 no cdp enable
Example:
Router(config-subif)# no cdp enable
Router(config-subif)#
Step 5 bridge-group number
Example:
Router(config-subif)# bridge-group 1
Router(config-subif)#
Step 6
exit
Example:
Router(config-subif)# exit
Router(config)#
Repeat these steps to configure more subinterfaces, as needed.
Configuration Example
The following configuration example shows a portion of the configuration file for the wireless LAN
scenario described in the preceding sections.
!
bridge irb
!
interface Dot11Radio0
no ip address
!
broadcast-key vlan 1 change 45
!
!
encryption vlan 1 mode ciphers tkip
!
ssid cisco
!
ssid ciscowep
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
9-6
vlan 1
authentication open
authentication network-eap eap_methods
authentication key-management wpa
vlan 2
Chapter 9 Configuring a Wireless LAN Connection
Purpose
Enables IEEE 802.1q encapsulation on the
specified subinterface.
Disables the Cisco Discovery Protocol (CDP) on
the wireless interface.
Assigns a bridge group to the subinterface.
Exits subinterface configuration mode, and
enters global configuration mode.
OL-6426-02