Cisco 1812W - Integrated Services Router Wireless Configuration Manual page 91

Chapter 7 Configuring VPNs Using an IPSec Tunnel and Generic Routing Encapsulation
Command or Action
Step 4
domain name
Example:
Router(config-isakmp-group)# domain
company.com
Router(config-isakmp-group)#
Step 5 exit
Example:
Router(config-isakmp-group)# exit
Router(config)#
Step 6
ip local pool {default | poolname}
[low-ip-address [high-ip-address]]
Example:
Router(config)# ip local pool dynpool
30.30.30.20 30.30.30.30
Router(config)#
Enable Policy Lookup
Perform these steps to enable policy lookup through AAA, beginning in global configuration mode:
Command or Action
Step 1 aaa new-model
Example:
Router(config)# aaa new-model
Router(config)#
Step 2
aaa authentication login {default | list-name}
method1 [method2...]
Example:
Router(config)# aaa authentication login
rtr-remote local
Router(config)#
OL-6426-02
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
Purpose
Specifies group domain membership.
Exits IKE group policy configuration mode, and
enters global configuration mode.
Specifies a local address pool for the group.
For details about this command and additional
parameters that can be set, see the
Technologies Command Reference.
Purpose
Enables the AAA access control model.
Specifies AAA authentication of selected users at
login, and specifies the method used.
This example uses a local authentication database.
You could also use a RADIUS server for this. See
the Cisco IOS Security Configuration Guide
the Cisco IOS Security Command Reference
details.
Configure a VPN
Cisco IOS Dial
and
for
7-5