Cisco 1812W - Integrated Services Router Wireless Configuration Manual page 137

Chapter 13 Configuring Dial Backup and Remote Management
Command
Step 8
ip address negotiated
Example:
Router(config-if)# ip address negotiated
Router(config-if)#
Step 9
encapsulation encapsulation-type
Example:
Router(config-if)# encapsulation ppp
Router(config-if)#
Step 10 dialer pool number
Example:
Router(config-if)# dialer pool 1
Router(config-if)#
Step 11 dialer string dial-string[:isdn-subaddress]
Example:
Router(config-if)# dialer string 384040
Router(config-if)#
Step 12 dialer-group group-number
Example:
Router(config-if)# dialer group 1
Router(config-if)#
Step 13
exit
Example:
Router(config-if)# exit
Router(config)#
Step 14 dialer-list dialer-group protocol protocol-name
{permit | deny | list access-list-number |
access-group}
Example:
Router(config)# dialer-list 1 protocol ip
permit
Router(config)#
OL-6426-02
Configuring Dial Backup and Remote Management Through the ISDN S/T Port
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
Purpose
Specifies that the IP address for the interface is
obtained through PPP/IPCP (IP Control Protocol)
address negotiation. The IP address is obtained
from the peer.
Sets the encapsulation type to PPP for the
interface.
Specifies the dialer pool to be used.
In the example, the dialer pool 1 setting associates
the dialer 0 interface with the BRI0 interface
because the BRI0 dialer pool-member value is 1.
Specifies the telephone number to be dialed.
Assigns the dialer interface to a dialer group
(1–10).
Exits the dialer 0 interface configuration mode,
and enters global configuration mode.
Creates a dialer list for packets of interest to be
forwarded through the specified interface dialer
group.
In the example, dialer-list 1 corresponds to
dialer-group 1.
For details about this command and additional
parameters that can be set, see the
Technologies Command Reference.
Cisco IOS Dial
13-11