Configuring Basic Parameters
Configure the ATM WAN Interface
This procedure applies only to the Cisco 1801, Cisco 1802, and Cisco 1803 models.
Perform these steps to configure the ATM interface, beginning in global configuration mode:
Command
Step 1
For the Cisco 1803 only:
controller dsl 0
mode atm
exit
Example:
Router(config)# controller dsl 0
Router(config-controller)# mode atm
Router(config-controller)# exit
Router(config)#
Step 2
interface type number
Example:
Router(config)# interface atm0
Router(config-int)#
Step 3
ip address ip-address mask
Example:
Router(config-int)# ip address
200.200.100.1 255.255.255.0
Router(config-int)#
Step 4
no shutdown
Example:
Router(config-int)# no shutdown
Router(config-int)#
Step 5
exit
Example:
Router(config-int)# exit
Router(config)#
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
1-8
Chapter 1
Purpose
For routers using the G.SHDSL signaling, perform
these commands. Ignore this step for routers using
ADSL signaling.
Enters interface configuration mode.
Sets the IP address and subnet mask for the ATM
interface.
Enables the ATM 0 interface.
Exits interface configuration mode and returns to
global configuration mode.
Basic Router Configuration
OL-6426-02