Verify The Configuration - Cisco 1812W - Integrated Services Router Wireless Configuration Manual

Configure DSL Signaling Protocol
Command
Step 5
line-mode {4-wire enhanced | 4-wire standard |
2-wire}
Example:
Router(config-controller)# line-mode 4-wire
standard
Router(config-controller)#
Step 6 ignore-error-duration number
Example:
Router(config-controller)#
ignore-error-duration 15
Router(config-controller)#
Step 7 exit
Example:
Router(config-controller)# exit
Router(config)#
If you are integrating your Cisco router into a European network, please use one of the following
Note
commands:
For CO mode, use the dsl dsl-mode shdsl symmetric annex {A | B | B-ANFP} command to choose
annex B or B-ANFP.
For CPE mode, use the dsl dsl-mode shdsl symmetric annex {A | A-B | A-B-ANFP | B | B-ANFP} to
choose any option except option A.
The router uses annex A by default (United States).

Verify the Configuration

You can verify that the configuration is set the way you want using the show controllers dsl command
from privileged EXEC mode.
Router# show controllers dsl 0
DSL 0 controller UP
SLOT 0: Globespan xDSL controller chipset
Line Mode: Four Wire Standard Mode
DSL mode: SHDSL Annex A
Frame mode: Utopia
Configured Line rate: Auto
Line Re-activated 6 times after system bootup
LOSW Defect alarm: ACTIVE
CRC per second alarm: ACTIVE
Line termination: CPE
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
4-8
Current 15 min CRC: 0
Current 15 min LOSW Defect: 0
Chapter 4 Configuring PPP over ATM with NAT
Purpose
Specifies whether this DSL connection is
operating in 2-wire, 4-wire standard, or 4-wire
enhanced mode.
line mode 4-wire will default to 4-wire
Note
enhanced mode.
Specifies how long, 15 to 30 seconds, to ignore
errors.
Exits controller configuration mode, returning to
global configuration mode.
OL-6426-02