Cisco 1812W - Integrated Services Router Wireless Configuration Manual page 109

Chapter 9 Configuring a Wireless LAN Connection
Command or Action
Step 3
bridge-group number
Example:
Router(config)# bridge-group 1
Router(config)#
Step 4
bridge-group parameter
Example:
Router(config)# bridge-group
spanning-disabled
Router(config)#
Step 5
interface name number
Example:
Router(config)# interface bvi 1
Router(config)#
Step 6
ip address address mask
Example:
Router(config)# ip address 10.0.1.1
255.255.255.0
Router(config)#
Repeat
Configure Radio Station Subinterfaces
Perform these steps to configure subinterfaces for each root station, beginning in global configuration
mode:
Command
Step 1 interface type number
Example:
Router(config)# interface dot11radio 0.1
Router(config-subif)#
Step 2 description string
Example:
Router(config-subif)# description Cisco open
Router(config-subif)#
OL-6426-02
Step 2 through Step 6 above for each VLAN that requires a wireless interface.
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
Configure Radio Station Subinterfaces
Purpose
Assigns a bridge group to the interface.
Sets other bridge parameters for the bridging
interface.
Enters configuration mode for the virtual bridge
interface.
Specifies the address for the virtual bridge
interface.
Purpose
Enters subinterface configuration mode for the
root station interface.
Provides a description of the subinterface for the
administrative user.
9-5