Configuration Example
Verifying Your Configuration
Use the show ip nat statistics command in privileged EXEC mode to verify NAT configuration. You
should see verification output similar to the following example:
Router# show ip nat statistics
Total active translations: 0 (0 static, 0 dynamic; 0 extended)
Outside interfaces:
FastEthernet4
Inside interfaces:
Vlan1
Hits: 0
CEF Translated packets: 0, CEF Punted packets: 0
Expired translations: 0
Dynamic mappings:
-- Inside Source
[Id: 1] access-list 1 interface Dialer0 refcount 0
Queued Packets: 0
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
3-10
Misses: 0
Chapter 3
Configuring PPP over Ethernet with NAT
OL-6426-02