Cisco 1812W - Integrated Services Router Wireless Configuration Manual page 139

Chapter 13 Configuring Dial Backup and Remote Management
dialer string 384020
dialer-group 1
peer default ip address pool isdn
!
ip local pool isdn 192.168.2.1
ip http server
ip classless
ip route 0.0.0.0 0.0.0.0 192.168.2.1
ip route 40.0.0.0 255.0.0.0 30.1.1.1
!
dialer-list 1 protocol ip permit
!
Configuring Dial Backup and Remote Management Through a
V.92 Modem
Perform the following tasks to configure dial backup and remote management through the V.92 modem
on your Cisco 1811 router:
•
•
Asynchronous Interface Configuration
Perform these steps to configure the V.92 modem for use as a backup interface, beginning in global
configuration mode:
Command
Step 1 interface type number
Example:
Router(config)# interface async 1
Router(config-if)#
Step 2 ip unnumbered type number
Example:
Router(config-if)# ip unnumbered
FastEthernet 2
Router(config-if)#
Step 3 encapsulation encapsulation-type
Example:
Router(config-if)# encapsulation ppp
Router(config-if)#
OL-6426-02
Asynchronous Interface Configuration
Line Configuration
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
Configuring Dial Backup and Remote Management Through a V.92 Modem
Purpose
Enters interface configuration mode for the
asynchronous serial interface. Enter the number of
the interface you want to configure.
Conserves IP addresses by configuring the
asynchronous interface as unnumbered, and
assigns the IP address of the interface type that
you want to leverage.
Sets the encapsulation type to PPP for the
interface.
13-13