Vlansetting; Optional Feature Parameters - Cisco ATA-186 Administrator's Manual

Chapter 5 Parameters and Defaults
Table 5-6 OpFlags Parameter Operational Features to Turn On or Off (continued)
Bit Number Definition
10 Reserved.
11 If Bit 11=0,the Cisco ATA requests the device hostname from the DHCP server.
If Bit 11=1, the Cisco ATA uses the device hostname that is specified in DHCP option 12.
12-27 Reserved.
28-31 To configure the Cisco ATA to prompt the user for the UIPassword when the user attempts to perform a factory
reset or upgrade using the voice configuration menu, configure bits 28 to 31 with the value of 6. Any other value
for these bits means that the Cisco ATA will not prompt the user for the UIPassword in these cases.

VLANSetting

Description
This parameter is for firmware version 2.15 and 2.14ms, and above.
Bitmap definitions are as follows for the VLANSetting parameter:
•
•
•
•
•
Value Type
Bitmap
Default
0x0000002b
Voice Configuration Menu Access Code
324

Optional Feature Parameters

This section describes the following parameters, which are located in the wheat-colored portion of the
Cisco ATA Web Configuration Page:
•
•
•
•
OL-3410-01
Bits 0-2—Specify VLAN CoS bit value (802.1P priority) for TCP packets.
Bits 3-5—Specify VLAN CoS bit value (802.1P priority) for UDP packets.
Bits 6-17—Reserved.
Bits 18-29—User-specified 802.1Q VLAN ID.
Bits 30-31—Reserved.
NPrintf, page 5-36
TraceFlags, page 5-36
RingOnOffTime, page 5-37
IPDialPlan, page 5-38
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SIP)
Optional Feature Parameters
5-35