Procedure To Refresh The Cisco Ata; Procedure To Reset The Cisco Ata; Upgrading The Sip Signaling Image - Cisco ATA-186 Administrator's Manual

Upgrading the SIP Signaling Image

Procedure to Refresh the Cisco ATA

To refresh the Cisco ATA, enter the following command from your web browser:
http://<ipaddress>/refresh
where ipaddress is the IP address of the Cisco ATA that you are refreshing.

Procedure to Reset the Cisco ATA

To reset the Cisco ATA, enter the following command from your web browser:
http://<ipaddress>/reset
where ipaddress is the IP address of the Cisco ATA that you are resetting.
Upgrading the SIP Signaling Image
For instructions on how to upgrade the Cisco ATA to the most recent SIP signaling image, refer to the
following list:
•
•
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SIP)
3-22
To use the recommended TFTP method of upgrading the Cisco ATA, see the
Signaling Image from a TFTP Server" section on page
In the rare instance that you are not using the TFTP server to configure the Cisco ATA and to obtain
software upgrades, you must manually upgrade to the latest signaling image immediately after the
Cisco ATA boots up. In this case, see the
page 8-2.
Chapter 3
8-1.
"Upgrading the Signaling Image Manually" section on
Configuring the Cisco ATA for SIP
"Upgrading the
OL-3410-01