Voice Configuration Menu - Cisco ATA-186 Administrator's Manual

Chapter 3 Configuring the Cisco ATA for SIP
Without Using a DHCP Server
Use the following procedure if you are not using a DHCP server in your environment but are still using
a TFTP server to obtain the Cisco ATA configuration file:
Procedure
Set the DHCP parameter to 0.
Step 1
Set the UseTFTP parameter to 1.
Step 2
Set the Cisco ATA parameter TftpURL to the IP address or URL of the TFTP server. For more
Step 3
information on setting the TftpURL parameter, see the
Note
If you have done already done so, statically configure the following parameters using the voice
Step 4
configuration menu (see the
parameters you need to configure for the Cisco ATA to obtain network connectivity:
•
•
•
Other parameters that are normally supplied by DHCP may be provided statically by configuring their
values. These parameters are:
•
•
•
•
•
This completes the parameter settings you need to configure in order for the Cisco ATA to contact the
TFTP server (without using DHCP) that will contain the configuration file for the Cisco ATA.

Voice Configuration Menu

The main reasons to use the voice configuration menu are to establish IP connectivity for the Cisco ATA
if a DHCP server is not being used in your network environment, and to reset the Cisco ATA to its
factory values if necessary. You can also use the voice configuration menu if you need to configure a
small number of parameters or if the web interface and TFTP configuration are not available.
OL-3410-01
If you are not using a DHCP server to provide the TFTP server location, you must manually enter
the TftpUrl using either the voice configuration menu or the Web configuration page.
"Voice Configuration Menu" section on page
StaticIP
StaticRoute
StaticNetMask
DNS1IP
DNS2IP
NTPIP
AltNTPIP
Domain
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SIP)
Voice Configuration Menu
"TftpURL" section on page
3-15). These are the
5-5.
3-15