Nattimer; Operating Parameters - Cisco ATA-186 Administrator's Manual

Chapter 5 Parameters and Defaults

NatTimer

Description
This parameter allows you to specify a retransmission interval for sending a dummy packet to NatServer.
The interval is in seconds and is specified in bits 0-11 of this parameter. The upper 20 bits are reserved
and should be set to 0.
Value Type
Bitmap
Default
0, which means that no dummy packets will be sent to the NatServer.
Voice Configuration Menu Access Code
208

Operating Parameters

This section describes the following parameters, which are located in the green portion of the Cisco ATA
Web Configuration Page:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
OL-3410-01
LBRCodec, page 5-20
AudioMode, page 5-20
RxCodec, page 5-21
TxCodec, page 5-22
NumTxFrames, page 5-22
CallFeatures, page 5-23
PaidFeatures, page 5-24
CallerIdMethod, page 5-25
FeatureTimer, page 5-26
Polarity, page 5-27
ConnectMode, page 5-28
AutMethod, page 5-30
TimeZone, page 5-30
NTPIP, page 5-30
AltNTPIP, page 5-31
DNS1IP, page 5-31
DNS2IP, page 5-31
UDPTOS, page 5-32
SigTimer, page 5-32
OpFlags, page 5-34
VLANSetting, page 5-35
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SIP)
Operating Parameters
5-19