Creating Unique And Common Cisco Ata Configuration Files - Cisco ATA-186 Administrator's Manual

Configuring the Cisco ATA Using a TFTP Server
For an example of how to configure parameters for the TFTP Server configuration method, see the
"Creating Unique and Common Cisco ATA Configuration Files" section on page
Be sure to configure the UseSIP parameter to the value of 1 to enable the SIP protocol. This parameter
Note
is 0 (for H.323) by default.

Creating Unique and Common Cisco ATA Configuration Files

If you have many Cisco ATAs to configure, a good approach is to create two configuration files:
•
•
The following procedure demonstrates the steps needed to create these configuration files.
The parameters used in this section help illustrate the process of creating a unique Cisco ATA
Note
configuration file, and do not include all required SIP parameters in the examples. See
and Additional SIP Services,"
additional configurable features. Also, refer back to
steps.
Procedure
Use the example_uprofile.txt file as a template for creating a text file of values that are common to one
Step 1
group of Cisco ATAs. The example_uprofile.txt file is included in the software-release zip file and
contains all default values. This file is shown without its annotations in the
Template" section on page
Copy the example_uprofile.txt file and save it with a meaningful name, such as common.txt.
Configure all common parameters by editing the text file as desired. For example, you might configure
Step 2
some parameters as follows:
ToConfig:0
UseTftp:1
DHCP:1
TFtpURL:10.10.10.1
UseSIP:1
Tip
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SIP)
3-8
One file that will contain only parameter values unique to a specific Cisco ATA.
One file for parameters that will be configured with values common to a group of Cisco ATAs. If
this file is updated, all Cisco ATA devices in this common group can obtain the new configuration
data in a batch-mode environment.
5-2.
It is helpful to always include the parameter/value of ToConfig:0 in the Cisco ATA
configuration file so that every time this file is downloaded to the Cisco ATA, it will set
ToConfig to 0, which the appropriate value for this parameter once the Cisco ATA has been
configured. If ToConfig is 1, the Cisco ATA will continue to unnecessarily contact the TFTP
server.
for complete listings and descriptions of required parameters and
Table 3-3 on page 3-5
Chapter 3 Configuring the Cisco ATA for SIP
3-8.
Chapter 4, "Basic
for all main configuration
"Configuration Text File
OL-3410-01