Network Statistics - Cisco 6941 - Unified IP Phone Slimline VoIP Administration Manual

Chapter
Table 8-2 Network Setup Area Items (continued)
Item
DSCP for Call Control
DSCP for Configuration
DSCP for Services
Security Mode
Web Access Enabled
Span to PC Port
PC VLAN
LLDP-MED: Switch Port
LLDP Power Priority
LLDP Asset ID
CDP: PC Port
CDP: SW Port

Network Statistics

The following network statistics hyperlinks on a phone's web page provide information about network
traffic on the phone. To display a network statistics area, access the web page for the phone as described
in the
•
Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications Manager 8.5 (SCCP and SIP)
OL-23769-01
Description
DSCP IP classification for call control signaling.
DSCP IP classification for any phone configuration transfer.
DSCP IP classification for phone-based services.
Displays the security mode that is set for the phone.
Indicates whether web access is enabled (Yes) or disabled (No) for the phone.
Indicates whether the phone will forward packets transmitted and received on the network port
to the access port.
VLAN used to identify and remove 802.1P/Q tags from packets sent to the PC.
Indicates whether Link Layer Discovery Protocol Media Endpoint Discovery (LLDP-MED) is
enabled on the switch port.
Advertises the phone's power priority to the switch, enabling the switch to appropriately
provide power to the phones. Settings include:
• Unknown—default
• Low
• High
Critical
•
Identifies the asset ID assigned to the phone for inventory management.
Indicates whether CDP is supported on the PC port (default is enabled).
Enable CDP on the PC port when Cisco VT Advantage/Unified Video Advantage (CVTA) is
connected to the PC port. CVTA does not work without CDP interaction with the phone.
When CDP is disabled in Cisco Unified Communications Manager, a warning is displayed,
indicating that disabling CDP on the PC port prevents CVTA from working.
The current PC and switch port CDP values are shown on the Settings menu.
Indicates whether CDP is supported on the switch port (default is enabled).
Enable CDP on the switch port for VLAN assignment for the phone, power negotiation, QoS
management, and 802.1x security.
Enable CDP on the switch port when the phone is connected to a Cisco switch.
When CDP is disabled in Cisco Unified Communications Manager, a warning is presented,
indicating that CDP should be disabled on the switch port only if the phone is connected to a
non-Cisco switch.
The current PC and switch port CDP values are shown on the Settings menu.
"Accessing the Web Page for a Phone" section on page
Ethernet Information—Displays information about Ethernet traffic.
this area.
Network Statistics
8-2.
Table 8-3 describes the items in
8-7