Cisco 6941 - Unified IP Phone Slimline VoIP Administration Manual page 97

Chapter
Table 5-1 Telephony Features for the Cisco Unified IP Phone (continued)
Feature Description
Reroute Direct Calls to Reroutes a direct call to users' mobile phone to the
Remote Destination to enterprise number (desk phone). For an incoming
Enterprise Number call to remote destination (mobile phone), only
remote destination rings; desk phone does not ring.
When the call is answered on their mobile phone,
the desk phone displays a Remote In Use message.
During these calls, users can make use of various
features of their mobile phone.
Remote Port Allows the administrator to configure the speed
Configuration and duplex function of the phone Ethernet ports
remotely by using Cisco Unified CM
Administration. This enhances the performance for
large deployments with specific port settings.
Note
Ring Tone Setting Identifies ring type used for a line when a phone
has another active call.
Secure Conference
Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications Manager 8.5 (SCCP and SIP)
OL-23769-01
If the ports are configured for Remote Port
Configuration in Cisco Unified CM, the
data cannot be changed on the phone.
• Allows secure phones to place conference
calls using a secured conference bridge.
As new participants are added by using
•
Confrn, Join, cBarge, Barge softkeys or
MeetMe conferencing, the secure call icon
displays as long as all participants use secure
phones.
The Conference List displays the security level
•
of each conference participant. Initiators can
remove non-secure participants from the
Conference List. (Non-initiators can add or
remove conference participants if the
Advanced Adhoc Conference Enabled
parameter is set.)
Telephony Features Available for the Cisco Unified IP Phone
Configuration Reference
For more information, see the Cisco Unified
Communications Manager Features and
Services Guide, Cisco Unified Mobility.
To configure the parameter in the Cisco
Unified CM Administration application,
choose Device > Phone, select the appropriate
IP phone, and scroll to the Product Specific
Configuration Layout pane (Switch Port
Remote Configuration or PC Port Remote
Configuration).
To configure the setting on multiple phones
simultaneously, configure the remote
configuration in either Enterprise Phone
Configuration (System > Enterprise Phone
Configuration) or Common Phone Profile
Configuration (Device > Device Settings >
Common Phone Profile. 
(Switch Port Remote Configuration or PC Port
Remote Configuration)
For more information, see the following:
Cisco Unified Communications Manager
•
Administration Guide,
Configuration.
"Creating Custom Phone Rings" section
•
on page 6-2.
For more information about security, see the
"Overview of Supported Security Features"
section on page 1-16.
For additional information, see the following:
Cisco Unified Communications Manager
•
System Guide, "Conference Bridges."
Cisco Unified Communications Manager
•
Administration Guide,
Bridge Configuration".
Cisco Unified Communications Manager
•
Security Guide.
Directory Number
"Conference
5-13