Installing Your Phone; Before You Begin; Connecting The Handset - Cisco SPA 525g User Manual

Installing Your Phone

This chapter describes how to install and connect your IP phone.

Before You Begin

Before you install and connect your phone, verify with your phone system administrator (if
applicable) that the network is ready for the phone, read the safety notices, and make sure you
have all the phone parts and documentation available.
!
CAUTION Do not plug a telephone line cord into the port marked AUX. The RJ-11 port marked AUX is
reserved for connection with the Cisco Attendant Console. It is not for use as a telephone line port or
IP device connection.

Connecting the Handset

STEP 1 Find the longer end of the coiled phone cord. Insert it into the back of the phone base
in the slot marked with a phone symbol. This port is labeled #5 on
STEP 2 Insert the short end of the handset cord into the jack at the bottom of the handset (not
shown).
Figure 1.
28