Cisco 6941 - Unified IP Phone Slimline VoIP Administration Manual page 79

Chapter
Table 4-1 Network Setup Menu Options (continued)
Option
PC VLAN
SW Port Setup
Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications Manager 8.5 (SCCP and SIP)
OL-23769-01
Description
Allows the phone to interoperate with 3rd party switches
that do not support a voice VLAN. The Admin VLAN ID
option must be set before you can change this option.
Speed and duplex of the network port. Valid values:
• Auto Negotiate
1000 Full—1000-BaseT/full duplex (Supported only
•
for Cisco Unified IP Phone 6945.)
• 100 Half—100-BaseT/half duplex
• 100 Full—100-BaseT/full duplex
10 Half—10-BaseT/half duplex
•
10 Full—10-BaseT/full duplex
•
If the phone is connected to a switch, configure the port
on the switch to the same speed/duplex as the phone, or
configure both to auto-negotiate.
If you change the setting of this option, you must change
the PC Port Configuration option to the same setting.
Network Setup Menu
To Change
Make sure the Admin VLAN ID
1.
option is set.
Scroll to the PC VLAN option,
2.
press the Edit softkey, and then
enter a new PC VLAN setting.
3. Press the Apply softkey, then
press Save.
1. Unlock network setup options.
2. Scroll to the SW Port Setup
option and then press the Edit
softkey.
Scroll to the setting that you
3.
want and then press the Select
button.
To configure the setting on multiple
phones simultaneously, enable the
Switch Port Remote Configuration in
the Enterprise Phone Configuration
(System > Enterprise Phone
Configuration).
If the ports are configured for
Note
Switch Port Remote
Configuration in Unified
CM, the data cannot be
changed on the phone.
4-5