Makita RM350D Setup Manual page 16

Robotic mower

Hide thumbs Also See for RM350D:

Drive the pegs on both sides of the connecting point using a plastic hammer.

Fig.17

► 1. Peg

NOTE: Make sure that the connection between the guide wire and the boundary wire is approximately 90°.

Install the guide wire by driving the pegs up to the charging station using a plastic hammer.

•

Drive the pegs at intervals of about 1 m, but use a narrower interval if the guide wire floats.

•

When making a curve, install the guide wire at an angle about 135°.

•

Install the guide wire in a straight line for 2 m or more in front of the charging station.

•

For other guide wire installation conditions, refer to "Guide wire installation conditions" (page 14).

Fig.18

► 1. Charging station 2. Guide wire

► a) 2 m or more b) About 135°

When finished installing the guide wire up to the charging station, pass the guide wire to the back of the charging station through the hole at the

bottom of the charging station tower.

Fig.19

► 1. Hole 2. Tower

NOTE: Cut the guide wire so that about 30 cm or more is left extending from the back of the charging station.

(b)

(a)

ENGLISH

Table of Contents