Makita RM350D Setup Manual page 14

Installing the Guide Wire
The guide wire leads the Robotic Mower to the charging station. This wire also guides the Robotic Mower to areas that the Robotic Mower works
less frequently due to topographical reasons, etc.
NOTE: Up to 2 guide wires can be installed.
NOTE: Do not branch the guide wire.
Guide wire installation conditions
a) 2 m or more
(b)
(a)
(a)
a) About 135° b) 50 cm or more c) 1 m or more d) 90° or less
a) 100 cm or more b) 50 cm or more
Image
(a)
(c)
(d)
(a)
(b)
As shown in the figure, lay the guide wire at least 2 m straight from the charging
station. The Robotic Mower may not be able to return to the charging station.
- When making a curve, install the guide wire at an angle about 135°. The Robotic
Mower may not be able to return to the charging station at an angle less than 90°.
- Make sure that the straight diagonal line is at least 50 cm.
- If the guide wire is to be laid in a curved line, lay it so that the bend radius is 1 m
or more.
The width of the work area should be at least 150 cm or more. Make sure that the
space on the left side of the guide wire is wide because the Robotic Mower passes
through the left side of the guidewire and returns to the charging station.
Do not let the guide wire cross the boundary wire.
14 ENGLISH
Condition