Makita RM350D Setup Manual page 9

2
1. Charging station 2. Guide wire 3. Boundary wire
a) 400 m or less b) 800 m or less
(a)
(a)
(c)
a) 8° or less b) 8° or more c) 1 m or more d) 20 cm
(a)
a) 1 m or more b) Less than 1 m
Image
1
(a) (b)
3
(b)
(d)
(b)
- The maximum length of the route starting from the charging station, guide wire,
boundary wire, and back in the charging station as illustrated in the figure should
be 400 m or less.
- The allowable space that you can limit by laying the boundary wire is up to 3,500
2
m .
- The maximum length of the boundary wire is up to 800 m including the islands
and sub areas.
- If there is a slope in the work area, lay the boundary wire on a slope of less than
8°.
- If you lay a boundary wire on a slope of more than 8°, lay an area of less than 8°
below the slope for at least 1 m.
- You cannot lay a boundary wire on a slope of more than 8° in the outermost work
area.
- Lay the boundary wire 20 cm away from the boundary between the slope and the
flat.
When using multiple stations and preparing multiple work areas, install the bound-
ary wires so that they are separated by distance of 1 m or more.
9 ENGLISH
Condition