Makita RM350D Setup Manual page 12

8. Cut the excess boundary wire using nippers leaving 1 cm of it from the connector.
Fig.10
9. Attach a connector to the other boundary wire in the same manner.
NOTE: Do not connect the connectors to the charging station at this time. The connection with the charging station is explained later in
"Connecting the Wires to the Charging Station" (page 18).
Making an island
If there are obstacles such as trees or rocks that cannot be cleared away in the mowing area, surround them with the boundary wire to make
islands.
• Install the boundary wire around obstacles to make islands. Use a narrow peg interval so that the distance from the obstacle is about 35 cm.
• Install two lines of the boundary wire going forth and back from the island close together (gap 0 cm). This will let the Robotic Mower traverse
the wires.
— Insert the two lines of boundary wire to the same peg.
NOTICE: Do not let the two lines of boundary wire cross each other. The Robotic Mower will stop due to an error.
1
Fig.11
► 1. Obstacle 2. Peg 3. Boundary wire
► a) About 35 cm b) Close together (gap 0 cm)
(a)
3
2
12 ENGLISH
(b)