Makita RM350D Setup Manual page 17

7. Insert and fix the guide wire in the groove in the center of the station base.
2
Fig.20
► 1. Groove 2. Station base
8. Attach a connector to the tip of the guide wire.
NOTE: Refer to page11 for how to attach the connector.
9. When installing a second guide wire, repeat steps 1 through 8.
NOTE: For details of connection with the charging station, refer to "Connecting the Wires to the Charging Station" (page 18).
Extending a Wire
When extending a wire, use a supplied coupler to connect the two wires.
1. Insert the wires to the left and right of the three connection ports of the supplied coupler.
1
Fig.21
► 1. Coupler 2. Wire
NOTE: Insert both wires as far as they will go.
NOTE: Wire extension is possible by inserting into any two of the connection ports, but it is recommended to use the left and right connection
ports in order to extend in a straight manner.
2. Clamp the coupler with pliers to fix the wires.
Fig.22
17 ENGLISH
1
2