Connectto The Network; Set Up Wi-Fi Client - Cisco 8800 Series User Manual

Connectto the Network

Procedure
Step 1 Hold the receiver in the cradle with one hand.
Step 2 Move the footstand with the other hand to change the angle.
(Optional) Adjust the footstand on the key expansion module and ensure that the phone and key expansion
Step 3
module are stable.
Step 4 (Optional) Press Self-view to check the camera angle.
Connectto the Network
You need to connect the conference phone to the telephone network.
• Wired connection—The phone is plugged into the network using an Ethernet cable.
• Wireless connection—The Cisco IP Phone 8861 and 8865 can connect to a Wireless Access Point using
• Virtual Private Network (VPN)—After the phone is connected to the network, it is set up to automatically
• Mobile and Remote Access Through Expressway—After you connect the phone to the network, it

Set Up Wi-Fi Client

The Cisco IP Phone 8861 and 8865 can access a Wi-Fi network, but a power adaptor is required to power the
phone. The Cisco IP Phone 8865NR cannot be used with a Wi-Fi network.
The phone PC port is disabled when Wi-Fi is enabled on your phone.
Note
Before You Begin
Your administrator needs to configure settings on the call control system to enable Wi-Fi access.
Procedure
If the phone is plugged into the Ethernet, unplug the Ethernet cable.
Step 1
Step 2
Press Applications
Step 3
Navigate to Admin settings > Network setup > Wi-Fi client setup > Wi-Fi sign in access.
Step 4 Navigate to Wireless and press On.
Step 5
Navigate to Wi-Fi sign in access and press On.
Step 6 Press Apply to save the changes, or press Revert to cancel the changes.
Cisco IP Phone 8800 Series User Guide
6
Wi-Fi.
connect into a protected network.
connects to the Expressway server automatically.
.
Your Phone