Draytek Vigor 160 Series User Manual page 55

After finished the above settings, click OK to save the settings and return to previous page.
Click any index 6 to get the following web page:
Available settings are explained as follows:
Item
Enable Channel
WAN Type
General Settings
ATM QoS
Vigor160 Series User's Guide

Subnet Mask – Type in the subnet mask.

Gateway IP Address – Type in gateway IP address.
DNS Server IP Address - Type in the primary IP address for
the router if you want to use Static IP mode. If necessary,
type in secondary IP address for necessity in the future.
Description
Check it to enable this channel.
The connections and interfaces created in every channel may
select a specific WAN type to be built upon.
VPI - Type in the value provided by your ISP.
VCI - Type in the value provided by your ISP.
Protocol - Select a proper protocol (PPPoA, PPPoE or MPoA)
for this channel.
Encapsulation - Choose a proper type for this channel. The
types will be different according to the protocol setting that
you choose.
Add VLAN Header – Check the box to enable VLAN tag
configuration.
VLAN Tag – Type the value as the VLAN ID number. Valid
settings are in the range from 1 to 4095. The network traffic
flowing on each channel will be identified by the system via
their VLAN Tags. Channels using the same WAN type may not
configure the same VLAN tag value.
Priority – Choose the number to determine the packet
priority for such VLAN. The range is from 0 to 7.
Such configuration is applied to upstream packets. Such
information will be provided by ISP. Please contact with your
45