Draytek Vigor 160 Series User Manual page 311

TCP WWW Timeout: 60 sec.
TCP SYN Timeout: 60 sec.
T e l n e t C o m m
T e l n e t C o m m
This command allows user to set general settings for QoS.
S y n t a x
S y n t a x
qos setup [-<command> <parameter> | ... ]
S y n t a x
S y n t a x
Parameter
[<command>
<parameter>|...]
-h
-m <mode>
-i <bandwidth>
-o <bandwidth>
-r <index:ratio>
-u <mode>
-p <ratio>
-t <mode>
-V
-I <bandwith>
-O <bandwidth>
-v 0
-v 1
-D
[...]
E x a m p l
E x a m p
Vigor160 Series User's Guide
a n d : q o s s e t u p
a n d : q o s s e t u p
D e s c r i p t i o n
D e s c r i p t i o n
e
l e
Description
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
Type it to display the usage of this command.
It means to define which traffic the QoS control settings will apply
to and eable QoS control.
0: disable.
1: in, apply to incoming traffic only.
2: out, apply to outgoing traffic only.
3: both, apply to both incoming and outgoing traffic.
Default is enable (for outgoing traffic).
It means to set inbound bandwidth in kbps (Ethernet WAN only)
The available setting is from 1 to 100000.
It means to set outbound bandwidth in kbps (Ethernet WAN only).
The available setting is from 1 to 100000.
It means to set ratio for class index, in %.
It means to enable bandwidth control for UDP.
0: disable
1: enable
Default is disable.
It means to enable bandwidth limit ratio for UDP.
It means to enable/disable Outbound TCP ACK Prioritize.
0: disable
1: enable
Show all the settings.
Minimum available non-VoIP Inbound Bandwidth when VoIP is
detected (Kbps).
Default value: half of WAN inbound bandwidth.
Minimum available non-VoIP Outbound Bandwidth when VoIP is
detected (Kbps).
Default value: half of WAN outbound bandwidth.
It means Auto bandwidth adjustment. Adjust to minimum In/Out
bandwidth setting (or half QoS bandwidth).
When VoIP detected, QoS In/Out bandwidth adjusted to minimum
values.
Set all to factory default (for all WANs).
It means that you can type in several commands in one line.
301