Draytek Vigor 160 Series User Manual page 54

PPPoE/PPPoA Client
MPoA (RFC1483/2684)
44

Ping Detect - The router sends an ICMP (Internet Control
Message Protocol) echo request every second to the host,
whose address is specified in the Ping IP field, to verify
the WAN connection. If the remote host does not respond
within 30 seconds, the WAN connection is deemed to have
failed.
Primary/Secondary Ping IP – If you choose Ping

Detect as detection mode, you have to type
Primary or Secondary IP address in this field for
pinging.
 Ping Gateway IP – If you choose Ping Detect as
detection mode, you also can enable this setting
to use current WAN gateway IP address for
pinging.
With the IP address(es) pinging, Vigor router can
check if the WAN connection is on or off.
TTL – Time To Live, the maximum allowed number

of hops to the ping destination. Valid values range
from 1 to 255.
 Ping Interval – Enter the interval for the system to
execute the PING operation.
Ping Retry – Enter the number of times that the

system is allowed to execute the PING operation
before WAN disconnection is judged.
Enter your allocated username, password and authentication
parameters according to the information provided by your
ISP.
ISP Access Setup

ISP Name – Type in the name of your ISP.

Username – Type in the username provided by ISP in
this field. The maximum length of the name you can set
is 80 characters.

Password – Type in the password provided by ISP in this
field. The maximum length of the password you can set
is 48 characters.

PPP Authentication – Select PAP only or PAP or CHAP
for PPP.

Always On – Check it to keep the network connection
always.
Idle Timeout – Set the timeout for breaking down the
Internet after passing through the time without any
action.
IP Address From ISP

Fixed IP – Click Yes to use this function and type in a
fixed IP address in the box of Fixed IP Address.
Obtain an IP address automatically – Click this button to
obtain the IP address automatically.

Router Name – Type in the router name provided by
ISP.

Domain Name – Type in the domain name that you have
assigned.
Specify an IP address – Click this radio button to specify
some data.

IP Address – Type in the private IP address.
Vigor160 Series User's Guide