Table of Contents
Advertisement
Transportation
Loading System MkII
Transportation
If there is a need to move the Loading System MkII once the unit
is assembled and loaded with ballast, it is important that it is
handled the correct way to prevent lifting accidents.
Lifting with fork lift truck
1. Place the forks underneath the Base into the fork guiding
profiles, see Figure 31. Lift the unit slowly and make sure that no
part on the Loading System MkII is obstructed.
2. Lift the unit and adjust the feet to their fully inserted position
to prevent damage during movement.
3. Make sure the unit is lifted to avoid obstructions along the
planned route, and move it to the new location. Lower the unit to
the ground and make sure it is level by adjusting the feet into the
desired position. When Loading System MkII is level, remove the
fork lift and execute the safety check over again.
Lifting with crane
4. The system must be lifted without the SkyReach inserted, as
per figure 32. Use 4 slings/chains with load capacity min 2000 kg
each. All slings/chains must have the same length to avoid tilting
the unit when lifting. Each sling or chain must be connected to
one lifting eye as shown in Figure 32.
5. Check for damaged or bent parts before lifting the SkyReach
to avoid the risk of losing parts. The unit must be stable and in
horizontal postion when lifting. Avoid obstructions and obstacle
during the lifting operation.
NOTE
is important that a lifting device with a capacity exceeding that
value is used. When the crane is used for lifting, ensure there
is no safety risk for any personnel on site. The crane must be
operated by a competent and trained operative.
36
Advertisement
Table of Contents
