Table of Contents
Advertisement
Assembly
Assembling the Loading System MkII
The following information and illustrations are a step by step
guide on how to rig a Loading System MkII including a SkyReach
Anchor unit successfully. The Loading System MkII can be used
with any of the three ballast options described. Please refer to the
appropriate instruction pertaining to the actual case.
Before attempting to rig a Loading System MkII unit, please make
sure you have the following tools:
• Hammer, 22 mm spanner or adjustable spanner for adjusting the feet
• Spirit level.
• Crane for installation of the SkyReach unit.
• Fork lift truck, or equivalent, for lifting the component parts.
Installation instructions for Loading System MkII
1. Make sure that the ground, where the Loading System MkII
is placed, is relatively flat. The Loading System MkII Base has
adjustable feet which are designed to adjust within a 5 degree
inclination. Use a fork lift truck to handle the Bottom Frame,
place the forks underneath the horizontal tubes into the fork
guiding profiles prior to lifting, see Figure 12. Place the Bot-
tom Frame on the ground. Use a spirit level to make sure that
the Bottom Frame is level. If not, rotate the feet by hand or
use a 22 mm spanner or a hammer to strike on the Adjust-
ing Bar to adjust the feet until the Bottom Frame is level, see
Figure 13.
20
Assembly
Loading System MkII
Advertisement
Table of Contents
