Table of Contents
Advertisement
Loading System MkII
Figure 12. Lifting the Bottom Frame with a fork lift truck.
Figure 13. Adjustment of the Foot height with a 22 mm spanner.
2. Place the four Corner Posts into the Bottom Frame, with the
welding nuts facing outwards. (When using the Precast Kent-
ledge as ballast, it is recommended to insert only the two rear
Corner Posts before loading the ballast.)
Make sure that the Corner Posts are inserted the correct
length into the sleeves. Check the Insertion Marking Label
position, see Figure 14.
Assembly
21
Advertisement
Table of Contents
