Table of Contents
Advertisement
Loading System MkII
NOTE
Make sure that the Lock Pin is properly installed, latch
is dropped and that it is secured with the wire. Under no
circumstances can a substitute Lock Pin other than ones
provided by Combisafe be used.
10.2. Connect the Fall Arrest Block. Make sure that the compo-
nent is correctly attached and secured to the SkyReach An-
chor. Figure 29 shows how the 6,2 m Falcon Fall Arrest Block
is attached to the anchor point.
Figure 29. Attaching a 6,2m Falcon Fall Arrest Block.
NOTE
It is strongly recommended that a retrieving rope is tied to the
Fall Arrest Block karabiner to enable the operative to pull the
cable out and allow simple connection to the operative's 0.3 m
harness extender. It is not recommended to leave the cable of
the block pulled out in this matter, due to possible damage to
the unit.
Assembly
33
Advertisement
Table of Contents
