Agency Compliance Information; Compliance Statements And Restrictions; Fcc Compliance Statements; Industry Canada (Ic) Compliance Statements - Honeywell 51306533 User Manual

Field device access point
Table of Contents

Advertisement

2. Agency Compliance Information

2.1

Compliance statements and restrictions

This section contains agency compliance information for Honeywell's OneWireless
FDAP.

FCC compliance statements

The Federal Communications Commission (FCC) compliance statements are as follows:
This device complies with Part 15 of the FCC Rules and Regulations. Operation of
the device is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply within the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiates radiofrequency energy and, if not
installed and used in accordance with these instructions, may cause harmful
interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference, in which case the user should correct the
interference at their own expense.
Intentional or unintentional changes or modifications must not be made to the FDAP
unless under the express consent of the party responsible for compliance. Any such
modifications could void the user's authority to operate the equipment and voids the
manufacturer's warranty.

Industry Canada (IC) compliance statements

The Industry Canada (IC) compliance statements are as follows:
To reduce potential radio interference to other users, the antenna type and its gain
must be chosen so that the equivalent isotropic radiated power (EIRP) is not more
than that permitted for successful communication.
Operation is subject to the following two conditions:
This device may not cause interference.
R200
OneWireless Field Device Access Point User's Guide
October 2010
Honeywell Confidential & Proprietary
17

Advertisement

Table of Contents
loading

Table of Contents