Wall Mounting; Communications Panel Mounting - Honeywell Q7055B1047 Installation Instructions Manual

Wall Mounting

It is also possible to mount the OVN server to a wall. The
following sequence describes how the server should be
prepared prior to mounting it on a wall (see Fig. 3).
Place the OVN server with the topside
down on the desk.
Remove the four feet from the bottom of
the OVN by pushing horizontally away from
the housing with a flat screwdriver.
Push the four inserts (included) fully and
horizontally into the housing.
Adjust the four retaining clips (included) on
top of the inserts. Fasten the retaining clips
with the included four screws.
Use the housing with the clips to mark the
positions of the four mounting holes on the
wall surface. Drill 1/8 in. (4 mm) holes for
the mounting screws (not included) and
secure the OVN server.
Fig. 3. OVN wall mount.
Q7055B1047 OPEN VIEW NET SERVER (OVN)

Communications Panel Mounting

It is also possible to mount the OVN Server in the
14006090-555151 series EBI Communications Panel
(see Fig. 4).
M25121
3
95-7711