Keypad Control Menu (M3); Selection Of Control Place - Honeywell NX series User Manual

7.3.3

Keypad control menu (M3)

In the Keypad Controls Menu, you can choose the control place, edit the frequency reference and change
the direction of the motor. Enter the submenu level with the
Code Parameter
P3.1 Control place
R3.2 Keypad reference
Direction (on
P3.3
keypad)
R3.4 Stop button
Table 7-2. Keypad control parameters, M3
7.3.3.1

Selection of control place

There are three different places (sources) which the frequency converter can be controlled from. For each
control place, a different symbol will appear on the alphanumeric display:
I/O terminals
Keypad (panel)
Fieldbus
Change the control place by entering the edit mode with the
browsed through with the
diagram on the next page.
STOP READY
I /Oterm
Keypad control
P1 P4
STOP READY
I/Oterm
Control Place
Keypad
Figure 7-6. Selection of control place
CONTROL KEYPAD
Min Max
1 3
Par. Par.
2.1.1 2.1.2
0 1
0 1
Control place
Browser buttons. Select the desired control place with the
I/Oterm
Control Place
I/O Remote
Control Place
enter
Keypad
Menu button right.
Unit Default Cust
1
Hz
0
1
Symbol
I/O term
Keypad
Bus/Comm
Menu button
READY
STOP
STOP READY
Keypad
ID Note
1=I/O terminal
125 2=Keypad
3=Fieldbus
0=Forward
123
1=Reverse
0=Limited function of Stop
button
114
1=Stop button always
enabled
right. The options can then be
Enter button. See the
STOP READY
I/Oterm
Control Place
I/O Remote
7
79(110)