Parameter Menu (M2) - Honeywell NX series User Manual

7
78(110)
7.3.2

Parameter menu (M2)

Parameters are the way of conveying the commands of the user to the frequency converter. The parameter
values can be edited by entering the Parameter Menu from the Main Menu when the location indication M2
is visible on the first line of the display. The value editing procedure is presented in Figure 7-5.
Push the Menu button right
group desired by using the
its parameters. Use again the
can proceed in two different ways: Pushing the
this, the parameter value starts to blink. You can now change the value in two different manners:
1
Just set the new desired value with the
button. Consequently, the blinking stops and the new value is visible in the value field.
2
Push the Menu button right
editing manner may come in handy, when a relatively greater or smaller value than that on the
display is desired. Confirm the change with the
The value will not change unless the Enter button is pushed. Pressing the
back to the previous menu.
Several parameters are locked, i.e. uneditable, when the drive is in RUN status. If you try to change the
value of such a parameter the text *Locked* will appear on the display. The frequency converter must be
stopped in order to edit these parameters.
The parameters values can also be locked using the function in menu M6 (see Chapter Parameter lock
(P6.5.2)).
You can return to the Main menu anytime by pressing the
The basic application package "All in One+" includes seven applications with different sets of parameters.
You will find the parameter lists in the Application Section of this manual.
Once in the last parameter of a parameter group, you can move directly to the first parameter of that group
by pushing the Browser button
See the diagram for parameter value change procedure on page 78.
READY
Keypad
Parameters
G1 G8
READY
Keypad
Min Frequency
13.95 Hz
Figure 7-5. Parameter value change procedure
CONTROL KEYPAD
once to move into the Parameter Group Menu (G#). Locate the parameter
Browser buttons and push the
Browser buttons to find the parameter (P#) you want to edit. From here you
Menu button right
Browser buttons
once again. Now you will be able to edit the value digit by digit. This
up.
Ke ypa d
Input signals
G1
Keypad
Basic parameters
P1 P18
Keypad
Min Frequency
enter 14.45 Hz
Menu button right
takes you to the edit mode. As a sign of
and confirm the change with the
Enter button.
Menu button left
G8
READY
Min Frequency
READY
again to enter the group and
Enter
Menu button left takes you
for 3 seconds.
READY
Keypad
13.95 Hz