Honeywell NX series User Manual page 103

7
102(110)
In the Applications information page, push the
there are as many as there are applications loaded into the frequency converter. Locate the application you
want information about with the
button right. Use again the Browser buttons to see the different pages.
Hardware (S6.8.5)
The Hardware information page provides information on the following hardware-related topics:
Page
6.8.5.1 Power unit type code
6.8.5.2 Nominal voltage of the unit
6.8.5.3 Brake chopper
6.8.5.4 Brake resistor
Table 7-11. Hardware information pages
Expander boards (S6.8.6)
In the Expander boards pages you find information about the basic and option boards connected to the
control board (see Chapter 6.2).
You can check the status of each board slot by entering the Expander boards page with the
right and using the Browser buttons
button right again to display the status of the board. The keypad will also display the program version of the
respective board when you push either one of the
If no board is connected to the slot the text 'no board' will be shown. If a board is connected to a slot but
the connection is somehow lost the text 'no conn.' is displayed. See Chapter 6.2 and Figure 6-23 and
Figure 6-24 for more information.
For more information on the expander board-related parameters, see Chapter 7.3.7.
READY
I/Oterm
Expander boards
E1 E5
Figure 7-26. Expander board information menus
Debug menu (S6.8.7)
This menu is meant for advanced users and application designers. Contact factory for any assistance
needed.
CONTROL KEYPAD
Menu button right
Browser buttons and then enter the Information pages with the Menu
Content
to choose the board whose status you wish to check. Push the
Browser
I/Oterm
B:NXOPTA2
E1 E2
READY
I/Oterm
A:NXOPTA1
E1 E2
to enter the Application pages of which
buttons.
I/Oterm
Software version
10001.0
I/Oterm
State
Run
Menu button
Menu
READY